Keep relays are organized in an , where each address (e.g., K0 ) contains eight individual bits labeled 0 through 7 .
In the world of Fanuc, Keep Relays are the machine’s permanent memory. Unlike the volatile bits that reset when the breaker flips, these are the "Exclusive" secrets of the builder. K12.3 wasn’t a Fanuc standard; it was a custom safety latch the builder had programmed into the ladder logic years ago. He changed the bit to The contactor in the cabinet clicked—a sharp, mechanical fanuc keep relay parameters exclusive
: Bypassing safety circuit interfaces or hiding specific system screens. Important Documentation Keep relays are organized in an , where each address (e
Keep Relays (K-parameters) are software switches in the Programmable Machine Control (PMC) that maintain their state (ON/OFF) even after a power cycle. Unlike standard parameters, Keep Relays are "exclusive" because their functions are defined by the Machine Tool Builder (MTB) , not Fanuc itself. Custom Functions: Unlike standard parameters
Use the cursor keys to find the specific K-address (e.g., K0005). Bits are numbered from left to right. Type the new bit value ( 0 or 1 ) and press INPUT . Reset Safety :