Manual ((top)) — Simrad Rf300 Installation

1.0 © Simrad / Navico Group. For official updates, refer to www.simrad-yachting.com.

Position the unit so the feedback arm is as close to parallel with the rudder arm as possible when the rudder is amidships. If the geometry is off, your autopilot will get "confused" by non-linear readings. 2. Making the Connection

: The unit typically uses a two-wire frequency interface for direct connection to autopilot computers. Refer to your specific autopilot computer manual (e.g., Robertson Junction Units ) for correct terminal assignments, often terminals 11 and 12. Technical Specifications Interface Two-wire variable frequency Supply Voltage 12–16V DC (via CAN or computer) Waterproof Rating IPx6 (Rugged/Sealed) Cable Length Comes with 10 meters (33 feet) Operating Temp -10°C to +55°C (+32°F to +131°F) Troubleshooting & Calibration DD15 Direct Drive Installation Manual - info-mediawinkel

to terminals 11 and 12 on older junction units like the .