Battery Charger 60108m Manual: Everstart

Comprehensive Guide to the EverStart 60108M Battery Charger The EverStart 60108M is a popular, budget-friendly automatic battery charger commonly sold at Walmart. Designed for the DIY mechanic and casual user, this unit is typically a 6/12 Volt, 10 Amp manual or automatic charger (Note: The "M" suffix often indicates a manual unit, meaning it does not automatically shut off unless specified on the packaging; always verify your specific unit's faceplate). This write-up consolidates the essential instructions, safety protocols, and operational steps found in the original user manual. Key Specifications

Voltage Compatibility: 6V and 12V lead-acid batteries (Standard, AGM, Gel, and Deep-cycle) Charge Rate: 10 Amps (fast charge) / 2 Amps (trickle/slow charge – depending on exact model variant) Engine Start: Some variants include a 30-50 Amp engine start assist (check your unit for the "Engine Start" selector) Cooling: Fan-cooled (Thermally controlled)

Safety First (Critical Warnings) Before connecting the charger, read the following from the official manual:

Explosive Gases: Batteries produce explosive hydrogen gas. Do not smoke near the battery. Avoid sparks and open flames. Ventilation: Always charge batteries in a well-ventilated area. Eye Protection: Wear safety goggles. Battery acid can cause permanent blindness. Marine Batteries: Remove the battery from the boat before charging (to prevent gas accumulation in the bilge). everstart battery charger 60108m manual

How to Operate the EverStart 60108M Step 1: Determine Your Battery Type

6V vs. 12V: Set the selector switch to match your battery’s voltage. Do not guess. Manual vs. Automatic: If your unit is a manual charger, you must monitor the voltage. Never leave a manual charger on overnight without checking it, as it will overcharge and destroy the battery.

Step 2: Connection Procedure (Follow this exact order) If charging battery IN the vehicle: Comprehensive Guide to the EverStart 60108M Battery Charger

Turn off the charger and unplug it. Set the rate/voltage switches to "OFF" or "0". Positive (Red) clamp → Connect to the Positive (POS, P, +) terminal. Negative (Black) clamp → Connect to a heavy gauge metal part of the engine block (away from the battery and fuel lines). Plug in the charger and set the switches.

If charging battery OUT of the vehicle:

Place the battery on a stable, non-conductive surface. Connect a 24-inch, 6-gauge insulated extension cable to the negative terminal first (if using a remote connection), OR follow the standard order: Positive to Positive, then Negative to Negative . Safety note: When disconnected, always handle clamps so they don't touch each other. non-conductive surface. Connect a 24-inch

Step 3: Setting the Charge Rate

2 Amp (Trickle): Use for small batteries (motorcycles, lawn tractors) or maintaining a fully charged battery. 10 Amp (Fast): Use for standard car, marine, or deep-cycle batteries that are deeply discharged. A typical car battery will take 3-6 hours at 10A. Engine Start (If equipped): Use only for cranking. Do not use this mode to charge.